4
11. Select File | Properties to display the "Prologix Properties" dialog box with the "Connect To" tab
selected.
12. Select the "Settings" tab.
13. These are the settings that seem to work well for us. Start with these settings and then later you can
modify them to your satisfaction.
• "Function, Arrow…" = Terminal Keys.
• "Backspace Key Sends" = Ctrl+H.
• "Emulation" = Auto detect.
• "Telnet Terminal ID" = ANSI
• "Backscroll Buffer Lines" = 500.
14. Click on the "Input Translation" button:
• Select "Shift-JIS"
• Click "OK".
15. Click on the "ASCII Setup" button:
• Check "Send line ends with line feeds".
• Check "Echo typed characters locally".
• Select "Line delay" = 0 milliseconds.
• Select "Character delay" = 0 milliseconds.
• Uncheck "Append line feeds to incoming line ends".
• Uncheck "Force incoming data to 7-bit ASCII".
• Check "Wrap lines that exceed terminal width".
• Click "OK".
16. In the "Prologix Properties" dialog box, click "OK".
17. You should be back to the main HyperTerminal window.
18. Enter "++ver" in lowercase and hit ENTER. You should receive a response similar to "Prologix GPIB-
USB Controller version 6.00". This is just a verification that you are actually communicating with the
Prologix device.
19. If you made it this far then you are successfully communicating with your Prologix GPIB-USB
Controller.
20. You can now proceed with configuring your controller to suit your needs. Refer to the Prologix GPIB-
USB Controller's manual for all the commands and their use.
21. Type "++mode 0" and hit ENTER. There is no response to this command.
22. Type "++mode" and hit ENTER. You should get a "0" back. This verifies that the Controller is in
DEVICE mode.
23.
I
f your source
device r
equi
res a speci
fic GP
IB
addres
s,
type
"++
addr
<a
ddr>",
where <add
r> is
the
GPIB address that your source device expects for the plotter, and hit ENTER. There is no response
to this command.
24.
Type
"++add
r"
and
hit
EN
TER.
Y
ou sho
uld s
ee
<a
ddr>.
This veri
fies t
hat
the
Controller
now has the
correct GPIB address.
25. Steps 26 and 27 apply only to GPIB-USB Controller 6.0. GPIB-USB Controller 4.2 does not support
"Listen Only".
26. If your source device's GPIB output is set to "Talk Only" you should set the Prologix GPIB-USB
Controller to "Listen Only". Type "++lon 1" and hit ENTER. There is no response. To this command.
27. Type "++lon" and hit ENTER. You should see "1". This verifies that the Controller is now in "Listen
Only" mode.
28. When you are satisfied with your controller's operation and configuration you can close
HyperTerminal.
29. Plug the GPIB-USB Controller directly, or using a GPIB cable, on to the GPIB connector of the source
device.
(15 pagine)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commenti su questo manuale